V2N Installation Guide Zigbee Module

Before setup can begin, verify the following: 

1. The door lock is physically installed according to the instructions from the door lock manufacturer
2. You have a ZigBee module that is compatible with your Hub. The module packaging should indicate which hub/app it is compatible with.
3. The door lock has not previously been used with another module. If it has, scroll further down the page and read about resetting the lock and module. 
4. The lock has a master PIN code (set and confirmed using the P button on the back of the door lock the first time the lock is started after installation). If you do not remember the master PIN code, go to the reset instructions that you will find when adding the door lock in the Eva Smart Home app. 

Setting up a new module

1. Remove the cover in front of the batteries.
2. Insert the Zigbee module.
3. Put the Zigbee module into pairing mode by removing and reinserting one battery in the door lock 5 times. The module will flash rapidly to indicate that it has entered pairing mode.
4. Open the Eva Smart Home app and tap “+” on the home screen, select “add device,” and select 
   “Yale Doorman door lock” from the list that appears.
5. Wait while the door lock connects to the Eva Hub and follow the instructions in the Eva Smart Home app.

How to reset the lock and module 

If the lock has previously been used with another module, the door must be reset first. 
Has the door lock been used with the Eva Smart Home app? Remember to delete the door lock from the app before resetting the door. 

Is the module installed in the door lock? Remove it and leave the door open while resetting.

 

Resetting the door lock 

1. Open the door, the door must be open in order to reset it
2. Remove the batteries from the lock 
3. Remove the plastic cover from the door lock

4. Unscrew the two upper and two lower screws to loosen the cover  (see illustration) 

5. Detach the interior part from the backplate and change the position of the Easy/advanced switch as illustrated. The position of the Easy/advanced switch is irrelevant in this case because the lock itself changes mode when the module is installed.
   
6. Insert all the batteries into the lock
7. When a lock voice prompt asks you for a master PIN code, enter it on the lock keypad and then press the physical “ P ” button on the inside of the lock. You can now use the lock with the master PIN code for as long as you want.
8. Screw the lock back together

Integrating the Eva module after resetting:

After the lock has been reset and a new master code has been set, you can insert the module. 
If the module does not enter pairing mode, you can try removing and reinserting one battery five times. The module should flash, and you can continue the process in the Eva Smart Home app. 

Emergency opening/opening from the outside when the battery level is low: 

If the batteries run out, you can open the door using a 9 V backup battery. Hold the battery against the terminals on the exterior escutcheon. Then use the code to unlock the door as usual (see illustration).